BLACK WIDOWVIRTUAL DYNO

What does your build really make?

Plug in your motor's specs, from big-block Mopars to K-series and 2JZs, and get an estimated horsepower and torque curve at the crank and the wheels, plus what your mods really add.

Estimated output

Altitude & weather

PRO

Dyno sheet

Crank horsepower and torque (lb-ft) by rpm, estimated

Build notes

Bolt-on mods: what they really make

FREE

Tick your mods to see a realistic gain range for this engine, based on independent dyno tests, not the number on the box.

Where these numbers come from

Bolt-on and tune ranges are our summary of typical independent results: back-to-back chassis-dyno and engine-dyno tests in magazines and shows (such as Hot Rod, MotorTrend, Street Muscle and Richard Holdener's LS tests) and owner before-and-after dyno data on enthusiast forums (such as K20a.org, Honda-Tech, LS1Tech and NASIOC). Manufacturer claims are not used; they are usually measured on a tuned car, at a single rpm, or against a heat-soaked baseline.

Assumptions: a healthy stock engine, quality parts, 91-93 octane where the engine calls for it, the same dyno and correction before and after. Ranges are percentages of this engine's estimated crank power, shown at the wheels using your transmission's loss. Turbo, supercharger, boost and pulley changes are run through the engine model at the new boost (with charge heat, intercooling and belt drag); the low end of their range allows for heat soak and boost taper. Nitrous adds 85-100% of the jetted shot. Gains do not simply add: they compound, the first restriction you remove is worth the most, and on modern computer-controlled and turbo engines most parts need a tune to show their full gain. A tune plus two or more breathing mods earns a stacking bonus.

Every engine and dyno is different, so treat these as a realistic expectation, not a promise.

Parts that fit this build

Save, compare & share

PRO

Build sheet

How the estimate works

Estimate, not a dyno pull. Real numbers depend on tuning, timing, cam timing events, intake and exhaust details, altitude and parts condition. These figures are for sea level (SAE standard air). At 4,700 ft, expect about 15% less on a naturally aspirated engine. Use this to compare builds, then verify on a real dyno.

The calculator works out how much air your engine can move through its heads, cam and intake at each rpm, how much of that air is burned efficiently given compression, fuel and knock limits, and what friction and pumping take away as rpm climbs. Boost raises the air charge (less charge heat if intercooled, minus belt drag on a supercharger), a carb that's too small trims the top end, and the head flow sets a soft ceiling on peak power.

Each preset is checked against its own published factory rating below. Factory ratings before 1972 are gross (no accessories, open exhaust); later ones and the imports are net (SAE or JIS).

Presets vs factory ratings

EngineEstimateFactory rating

Black Widow Virtual Dyno Pro

Start free trial

Already subscribed?